| Technical Specifications General  |  | | Sample Rates: 44.1, 48, 88.2, 96, 176.4, 192kHz from internal crystal or externally supplied clock (no sample rate conversion) | | | | Bit Depths: 24 bit I/O, 32 bit processing | | | | PCI Specification: | | | | | - PCI 2.2 Compliant | | - Form Factor: Universal Keyed, Short PCI Card | | - 3.3V I/O, 5V Tolerant | | - PCI Bus-Mastering DMA subsystem reduces CPU usage | | | | | E-MU E-DSP 32-bit DSP with 67-bit accumulator (double precision w/ 3 headroom bits) | | | | Hardware-accelerated, 32-channel mixing, and multi-effects processing | | | | Zero-latency direct hardware monitoring w/effects | | | | ASIO2, WDM/MME/DirectSound, x64 Drivers | | | | EDI (E-MU Digital Interface) proprietary 64-channel audio link over CAT-5 cable | | | | Anti-Pop speaker protection minimizes noise during power on/off | | | | Ultra-low jitter clock subsystem: < 1ns in PLL mode (44.1kHz, Opt. S/PDIF Sync) |
Analog Line Inputs (4) | | | Type: servo-balanced, DC-coupled, low-noise input circuitry | | | | A/D converter: AK5394A | | | | Level (software selectable): | | | | | - Professional: +4dBu nominal, 20dBu max (balanced) | | - Consumer: -10dBV nominal, 6dBV max (unbalanced) | | | | | Frequency Response (20Hz-20kHz): +0.0/-.03dB | | | | Dynamic Range (1kHz, A-weighted): 120dB | | | | Signal-to-Noise Ratio (A-weighted): 120dB | | | | THD+N (1kHz at -1dBFS): -110dB (.0003%) | | | | Stereo Crosstalk (1kHz at -1dBFS): < -120dB Analog Line Outputs (6) |
Analog Line Outputs (6) | | | Type: balanced, AC-coupled, 2-pole low-pass differential filter | | | | D/A converter: CS4398 | | | | Level (software selectable): | | | | | - Professional: +4dBu nominal, 20dBu max (balanced) | | - Consumer: -10dBV nominal, 6dBV max (unbalanced) | | | | | Frequency Response (20Hz - 20kHz): 0.0/-.06dB | | | | Dynamic Range (1kHz, A-weighted): 120dB | | | | Signal-to-Noise Ratio (A-weighted): 120dB | | | | THD+N (1kHz at -1dBFS): -105dB (.0006%) | | | | Stereo Crosstalk (1kHz at -1dBFS): < -115dB |
Combo Microphone Preamplifier/Hi-Z/Line Inputs (2) | | | Type: E-MU® XTC™ combo mic preamp and Hi-Z/line input w/ Soft Limiter | | | | Gain Range: +60dB | | | | Frequency Response (min gain, 20Hz-20kHz): +0.0/-0.1dB | | | | Stereo Crosstalk (1kHz min gain, -1dBFS): < -125dB | | | | Hi-Z Line Input: | | | | | - Input Impedance: 1Mohm | | - Max Level: +18dBV (20.2dBu) | | - Dynamic Range (A-weighted, 1kHz, min gain): 118dB | | - Signal-to-Noise Ratio (A-weighted, min gain): 118dB | | - THD+N (1kHz at -1dBFS, min gain): -105dB (.0006%) | | | | | Microphone Preamplifier: | | | | | - Input Impedance: 1.5Kohms | | - Max Level: +6dBV (+8.2dBu) | | - EIN (20Hz-20kHz, 150ohm, unweighted): -129.5dBu | | - Signal-to-Noise Ratio (A-weighted, min gain): 119dB | | - THD+N (1kHz at -1dBFS, min gain): -110dB (.0003%) | | - Phantom Power: 48V | | - Soft Limiter: 5dB max compression (software selectable) | |
Headphone Amplifier | | | Type: linear power amplifier | | | | D/A converter: CS4398 | | | | Gain Range: 85dB | | | | Maximum Output Power: 50mW | | | | Output Impedance: 22ohms | | | | Frequency Response (20Hz-20kHz): +0.0/-0.07dB | | | | Dynamic Range (A-weighted): 118.5dB | | | | Signal-to-Noise Ratio (A-weighted): 118dB | | | | THD+N (1kHz, max gain): 600ohm load: -96dB | | | | Stereo Crosstalk (1kHz at -1dBFS, 600 ohm load): < -100dB |
Phono Input (stereo) | | | Type: RIAA equalized phono input | | | | Maximum level: | | | | | - Professional: 60mV RMS | | - Consumer: 15mV RMS | | | | | Input Impedance: 47Kohm | | | | Frequency Response (20Hz - 20kHz): +0.1/-0.3dB | | | | Dynamic Range (A-weighted): 96dB | | | | Signal-to-Noise Ratio (15mV RMS unbal input, A-weighted): 96dB | | | | THD+N (1kHz, 15mV RMS input): -90dB (.003%) | | | | Stereo Crosstalk (1kHz at -1dBFS): < -80dB |
Digital I/O | | | S/PDIF: | | | | | | - 2 in/2 out coaxial (transformer coupled) | | | - 2 in/2 out optical (software switched with ADAT) | | - AES/EBU or S/PDIF format (software selectable) | | | | | ADAT: | | | | | - 8 channels, 24-bit @ 44.1/48kHz | | - 4 channels, 24-bit @ 88.2/96kHz (S-MUX compatible) | | - 2 channels, 24-bit @ 176.4/192kHz | | | | | MIDI | | | | | - 2 in, 2 out | |
Synchronization | | | Internal crystal sync at 44.1, 48, 88.2, 96, 176.4, 192kHz | | | | External sample rate sync via | | | | | | - ADAT (44.1 - 192kHz) | | - Optical S/PDIF (44.1 - 96kHz) | | | - Coaxial S/PDIF (44.1 - 192kHz) | | | | | SMPTE/LTC/MTC (via optional Sync Daughtercard) | | | | | | - 24, 25, 30 drop-frame, 30 non-drop | | - SMPTE to MTC, MTC to SMPTE Conversion | | | - SMPTE Striping | | - Flywheel/Jam/Regenerate | |
 Retail Box Contents
| | | E-MU 1010 PCI Card | | | | E-MU MicroDock M | | | | EDI (E-MU Digital Interface) cable (3 meters) | | | | Universal power adaptor | | | | MIDI breakout cable | | | | Quick Start installation guide | | | | E-MU Digital Audio Systems CD-ROM | | | | | - Windows® XP and XP x64 Drivers | | - E-MU PatchMix DSP | | - E-MU Power FX | | - E-MU E-DSP Effects Library - Owner's Manual and Tutorials | | | | | E-MU Production Tools Software Bundle CD-ROM | | | | | - Cakewalk SONAR LE | | - Steinberg Cubase LE | | - Ableton Live Lite 4 for E-MU | | - Steinberg Wavelab Lite | | - IK Multimedia AmpliTube LE | | - IK Multimedia T-RackS EQ | | - Minnetonka diskWelder BRONZE | | - SFX Machine LT | | - E-MU Proteus X LE (over 1000 sounds included) | |
Minimum System Requirements | | | Intel® or AMD® processor - 1 GHz or faster | | | | Intel, AMD or 100% compatible motherboard & chipset | | | | Microsoft® Windows® XP (SP 2) or Windows XP x64 | | | | 256MB System RAM | | | | 900MB of free hard disk space for full installation | | | | PCI 2.1 compliant slot for E-MU 1010 PCI card | | | | CD-ROM/CD-RW or DVD-ROM drive required for software installation | | | | XVGA Video (1024 X 768)
|
|
